PMM
Now available through APC Technology Group
Products found: 50
-
The single-phase V-network PMM’s Artificial Mains Network L1-150M1, with an equivalent circuit of 50 ohm // (1ohm + 5uH), meets the...FIND OUT MORE -
The objective of EMI Conducted tests is to define the amplitude of current Ic and Voltage Vc emission from the Device Under Test (DUT) onto the power...FIND OUT MORE -
The objective of EMI Conducted tests is to define the amplitude of current Ic and Voltage Vc emission from the Device Under Test (DUT) onto the power...FIND OUT MORE -
The objective of EMI Conducted tests is to define the amplitude of current Ic and Voltage Vc emission from the Device Under Test (DUT) onto the power...FIND OUT MORE -
The objective of EMI Conducted tests is to define the amplitude of current Ic and Voltage Vc emission from the Device Under Test (DUT) onto the power...FIND OUT MORE -
3-Phase, the AMN – Artificial Mains Network, also known as LISN – Line Impedance Stabilization Network – is the ancillary device...FIND OUT MORE -
The PMM Narda LP-02 Log Periodic Dipole Array obtain a broadband excellent VSWR characteristics thanks to its accurate design of the feed and...FIND OUT MORE -
The PMM Narda LP03 Log Periodic Dipole Array Antenna obtain a broadband excellent VSWR characteristics thanks to its accurate design of the feed and...FIND OUT MORE -
The PMM PS-400 Near Field Probe set includes three probes: a tip probe, a broadband probe, and a H-field probe. The tip probe is a precision E-field...FIND OUT MORE -
The PS-500 is a Near Field Probe set that includes four probes and a custom storage case. Designed for performance and ease of use, the PS-500’s...FIND OUT MORE -
The PMM Narda RA01 is designed to provide a good solution to measure low level fields from 9 kHz to 30 MHz (RA-01) and 150kHz to 30MHz (RA-01-HV) It...FIND OUT MORE -
The PMM Narda RF300 large loop antenna has been developed to meet the requirements of EN55015: 2006 + A2: 2009, section 9.9.1, which refers to...FIND OUT MORE -
The Pulse Limiter does not cause any significant change of the measured signal and loss in sensitivity on the measuring receiver. Its main function...FIND OUT MORE -
The PMM Switching Operation Box when used with the PMM 9010F FFT RF receiver with relevant software key provides a single channel Click Analyser...FIND OUT MORE -
Accurate in laboratory, fast in manufacturing and solidly built for field applicationsPMM 6630 is the ideal solution for RF power measurements in a...FIND OUT MORE -
The SBRF4 RF Switching Box is a versatile Accessory designed to operate the PMM Artificial Mains Networks (LISN) and the RF 300 Large Loop Antenna by...FIND OUT MORE -
When LISN (Line Impedance Stabilization Network) are not applicable to EMI conducted test because the current flowing is too high, the conducted...FIND OUT MORE -
The objective of the EMF radiation tests discussed here is to define the amplitude of current Ic and Voltage Vc induced by the Device Under Test...FIND OUT MORE